/* MountList for V1.3 */ /* Mount Entry for the new Console Handler */ NEWCON: Handler = L:Newcon-Handler Priority = 5 StackSize = 1000 # /* This is an example of a non-filing system mount using a handler written in C. */ SPEAK: Handler = L:Speak-Handler Stacksize = 6000 Priority = 5 GlobVec = -1 # /* This is an example of an alternative type of non-filing device mount, used to mount the non-buffered serial handler */ AUX: Handler = L:Aux-Handler Stacksize = 1000 Priority = 5 # /* This is a non-filing system device */ PIPE: Handler = L:Pipe-Handler Stacksize = 6000 Priority = 5 GlobVec = -1 # /* This is an example of a mount list entry for using the recoverable ram disk. Depending on the amount of memory you wish to devote to it, you may want to change the HighCyl value. */ RAD: Device = ramdrive.device Unit = 0 Flags = 0 Surfaces = 2 BlocksPerTrack = 11 Reserved = 2 Interleave = 0 LowCyl = 0 ; HighCyl = 21 Buffers = 5 BufMemType = 1 # /* Mount a 5.25" disk drive to be mounted as DF2: */ DF2: Device = trackdisk.device Unit = 2 Flags = 1 Surfaces = 2 BlocksPerTrack = 11 Reserved = 2 Interleave = 0 LowCyl = 0 ; HighCyl = 39 Buffers = 20 BufMemType = 3 # /* An example mount entry using the fast file system with a partition of the hard disk using the 2090 disk controller. PREP has been used to create the first partition (up to cylinder 20). The second partition is MOUNTed, using the following entry: NOTE: Some hard disk drivers require more stack than specified here. Some may required less. (The hard disk is not included; this is only an example.) */ FAST: Device = hddisk.device FileSystem = l:FastFileSystem Unit = 1 Flags = 0 Surfaces = 4 BlocksPerTrack = 17 Reserved = 2 Interleave = 0 LowCyl = 21 ; HighCyl = 800 Buffers = 30 GlobVec = -1 BufMemType = 1 Mount = 1 DosType = 0x444F5301 StackSize = 4000 # /* Let's say you have an A2000 with an internal drive, and an external drive, and you want to refer to the external drive as DF1: as well as DF2: Well, this MountList entry will do it for you. This technique can be extended to provide you with a drive A: and B: if you really want. */ DF1: Device = trackdisk.device Unit = 2 Flags = 1 Surfaces = 2 BlocksPerTrack = 11 Reserved = 2 Interleave = 0 LowCyl = 0 ; HighCyl = 79 Buffers = 20 BufMemType = 3 #