# $Id: rhslip0.config,v 1.3 1994/05/12 14:03:33 jraja Exp $ # # This file is the configuration file for the SANA-II SLIP # driver. It only contains one config line (aside from # the comments). The format of the line (in ReadArgs() # style) is: # # SERNAME/A,SERUNIT/A/N,SERBAUD/A/N,IPSTR/A,MTU/K/N,CD/S,7WIRE/S,EOFMODE/S # # SERNAME - The name of the serial device to use. # # SERUNIT - The unit number for the serial device. # # SERBAUD - The baud rate to use with the serial device. # # IPSTR - The IP address of the SLIP Device # # MTU - The MTU of the driver (optional) # # CD=CARRIERDETECT - If specified, causes the slip.device to pay attention # to the status of the carrier detect line. If this isn't # specified, slip.device ignores the CD signal. # # 7WIRE - If specified, causes slip.device to use seven wire handshaking # with the modem (strongly recommended for high baud rates). # # EOFMODE - If specified, causes rh(c)slip.device to use EOFMODE. This # reduces the CPU load, but it wont work with all different # serial devices. # serial.device 0 38400 135.7.20.2